Filter
Top Products
English
7
NOTE: If the gear case and motor housing become separated by more than
1/4", the tool must be serviced and re-assembled by a D
EWALT service center.
Failure to have the tool serviced may cause brush, motor and bearing failure.
4. Re-install screws to attach the gear case to the motor housing. Tighten
screws to 18 in./lbs. torque. Overtightening could cause screws to strip.
5. Re-install guard and correct flanges for the appropriate accessories.
Accessories
It is important to choose the correct guards, backing pads and flanges to use
with grinder accessories. See pages 6–8 for information on choosing the correct
accessories.
WARNING: Accessories must be rated for at least the speed recommended
on the tool warning label. Wheels and other accessories running over rated
accessory speed may burst and cause injury. Threaded accessories must have
a 5/8"-11 hub. Every unthreaded accessory must have a 7/8" arbor hole. If it
rubber backing pad
sanding disc
threaded clamp nut
Sanding Discs
4-1/2" and 5"
Cutting Wheels
Type 1 guard
Quick-change
wheel release
abrasive cutting wheel
clamp nut
Type 1 guard
Quick-change
wheel release
diamond cutting wheel
clamp nut
6" Cutting Wheels
Wire Wheels
3" wire cup
brush
4" wire wheel
Type 27 guard
Type 27 guard
Type 1 guard
Quick-change
wheel release
abrasive cutting wheel
clamp nut
Type 1 guard
Quick-change
wheel release
diamond cutting wheel
clamp nut