Filter
Top Products
AVAILABLE ACCESSORIES
Use only accessories recommended for this spin saw.
Follow instructions that accompany accessories. Use
of improper accessories may cause injury to the
operator or damage to the spin saw.
Use only accessories designed for this spin saw to
avoid severe injury or tool damage.
Do not use any accessory unless you have completely
read the instructions or Owner’s Manual for that
accessory.
LATERAL STYLE DRYWALL CUTTING BIT
This cutting bit has a fine spiral for removing high volumes
of material when cutting and leaving a smooth edge.
Use this cutter for cutting drywall.
GENERAL PURPOSE CUTTING BIT
This cutting bit has a coarse spiral for removing material
when being used for general cutting.
Use this general purpose cutter for cutting materials such
as wood, plastic and fiberglass.
TILE BIT
This cutting bit is designed specifically for use in cutting
wall tile and for removing grout from wall tile (see right).
NOTE: DO NOT use this tile bit for cutting floor tile or
for removing floor tile grout. Floor tile is harder than
wall tile and will cause damage to the bit.
UNPACKING AND CHECKING CARTON CONTENTS
If any part is missing or damaged, do not plug the
spin saw into the power source until the missing or
damaged part is replaced and assembly is complete.
Carefully unpack the spin saw and all its parts. Compare
against the “Spin Saw Components” chart.
NOTE: See Page 7 for illustration of parts and chart.
To avoid fire or toxic reaction, never use gasoline,
naphtha, acetone, lacquer thinner or similar highly
volatile solvents to clean the spin saw.
ACCESSORIES
WARNING
!
WARNING
!
CARTON CONTENTS
WARNING
!
WARNING
!
Tile Bit
6