Filter
Top Products
Supplemental Owner’s Manual 13
Using the Optional Trim Stop
The optional Trim Stop is used to securely hold small work-
pieces for cutting mortises.
Installing the Trim Stop
1. With the fence tilted to 90 degrees, slide the Trim Stop
over the fence face of the Domino joiner as shown. Make
sure the Trim Stop is fully seated onto the joiner’s fence.
2. Slide the two latch tabs inward.
3. Tighten the two thumbscrews.
Setting the Stop Width
1. Loosen the two green thumbscrews on the bottom of the
Trim Stop.
2. Place the workpiece between the two guides and slide the
guides inward.
3. Use the position gauge on the Domino joiner fence face
to center the workpiece.
4. With the side guides tight to the workpiece and the
workpiece centered in the position gauge, tighten the two
thumbscrews.
Hint: Make note of where the workpiece lines up
on the sight gauge, and use the sight gauge when
cutting the mortise on the mating frame for a T-joint
frame.
Locked
Position
Thumbscrew
Latch
Thumbscrews
Workpiece
Sight
Gauge
Using the Optional Hand Rail Fence
The optional hand rail fence is used to help stabilize rounded
workpieces that won’t otherwise rest at against the fence.
Installing the Hand Rail Fence
1. With the fence tilted to 90 degrees, slide the hand rail
fence over the fence face of the Domino joiner as shown.
Make sure the hand rail fence is fully seated onto the
joiner’s fence.
2. Slide the two latch tabs inward.
3. Tighten the two thumbscrews.
Locked
Position
Thumbscrew
Latch
If the hand rail fence is not sitting perfectly centered on the
mortising location, it can be shifted to the side by adjusting
the four gib screws.
Round
Stock
Gib Screws (4)