Filter
Top Products
4
Wall mounting LC 45
The charger LC 45 has two longitudinal slots on
its rear by which it can be suspended on walls
using two screws (e.g. button-headed or flat head
screw with a shaft diameter of 5 mm). Screw
both screws into the wall 96 mm apart until the
screwhead is protruding from the wall by approx.
4 mm.
Machine settings
Exchanging the battery pack
- Removing battery pack: Press the two buttons
(1.6) and slide the battery pack forwards to
remove.
- Inserting battery pack: Slide the battery pack
into the holder on the underside of the handle
until it latches into place (1.7).
To change the direction of rotation
The selector button (1.2) determines the direction
of rotation.
• Turn button from right to left = clockwise
rotation.
• Turn button from left to right = anticlockwise
rotation.
• Selector button in central position = circuit
interlock.
Shifting speeds
Change only when completely
stopped!
Using the shift lever (1.3), the speed can be
changed.
• 1. Speed: Lever forward - Figure 1 is visible.
• 2. Speed: Lever backwards - Figure 2 is visible.
Torque adjustment
By turning the adjustment ring (1.4) the required
torque can be adjusted. The arrow (1.5) aligns
with the adjusted state.
Drilling:
Drilling symbol on adjustment ring aligns with
the arrow = maximum torque.
Screwing:
Torque corresponding to setting:
• Position 1 = low torque
• Position 20 = high torque
Operation
Turn on by pressing button (1.1). Depending on
the pressure exerted on the button, the adjust-
ment of running speed can be varied infinitely.
Turn off by releasing the button (1.1). After
releasing the button, the chuck is stopped and
therefore, after-running of the equipment is
prevented.
Tool holding fixture, attachments
Make sure that the machine is
switched of and the battery block has been
removed before changing the tool holding fixture,
attachments and tools.
Chuck BF-FX
The chuck is used to clamp drills and bits.
Fitting:
- Place the chuck on the drill spindle (2.5) and
twist until the hexagon key (2.4) of the chuck
latches into the hexagon socket of the drill
spindle.