Filter
Top Products
BP130
Ni-MH Rechargeable Battery Pack
Instruction Sheet
This Rechargeable Battery Pack is designed for use
with the Fluke ScopeMeter Model 124 and with
Model 123 if the installed software is of version V2.00
or higher.
Chapter 2 of the Users Manual of the ScopeMeter
explains how to display the software version. This
Chapter also explains how to exchange the Battery
Pack.
After installation, charge the Battery Pack for at least
7 Hrs. with the ScopeMeter switched off.
• Nominal Voltage: 4.8 V
• Capacity: 3.0 Ah
• Lifetime: minimum 500 cycles at nominal charge
of 500 mA
• Temperature Ranges:
Operating: 0 °C to 50°C
Quick Charging: 10°C to 40°C
Trickle Charging: 10°C to 45°C
Storage: -40°C to 60°C
Performing a Refresh Cycles every 3 months, will
contribute to the lifetime of the Battery Pack.
To prevent damage to Equipment or Battery:
Fully charge before use.
Keep the battery cool
Do not dispose in open fire
Observe polarity
Do not solder directly to the cells
Do not short circuit
Store Batteries outside the Instrument
BP130
Ni-MH Rechargeable Battery Pack
Instruction Sheet
This Rechargeable Battery Pack is designed for use
with the Fluke ScopeMeter Model 124 and with
Model 123 if the installed software is of version V2.00
or higher.
Chapter 2 of the Users Manual of the ScopeMeter
explains how to display the software version. This
Chapter also explains how to exchange the Battery
Pack.
After installation, charge the Battery Pack for at least
7 Hrs. with the ScopeMeter switched off.
• Nominal Voltage: 4.8 V
• Capacity: 3.0 Ah
• Lifetime: minimum 500 cycles at nominal charge
of 500 mA
• Temperature Ranges:
Operating: 0 °C to 50°C
Quick Charging: 10°C to 40°C
Trickle Charging: 10°C to 45°C
Storage: -40°C to 60°C
Performing a Refresh Cycles every 3 months, will
contribute to the lifetime of the Battery Pack.
To prevent damage to Equipment or Battery:
Fully charge before use.
Keep the battery cool
Do not dispose in open fire
Observe polarity
Do not solder directly to the cells
Do not short circuit
Store Batteries outside the Instrument
BP130
Ni-MH Rechargeable Battery Pack
Instruction Sheet
This Rechargeable Battery Pack is designed for use
with the Fluke ScopeMeter Model 124 and with
Model 123 if the installed software is of version V2.00
or higher.
Chapter 2 of the Users Manual of the ScopeMeter
explains how to display the software version. This
Chapter also explains how to exchange the Battery
Pack.
After installation, charge the Battery Pack for at least
7 Hrs. with the ScopeMeter switched off.
• Nominal Voltage: 4.8 V
• Capacity: 3.0 Ah
• Lifetime: minimum 500 cycles at nominal charge
of 500 mA
• Temperature Ranges:
Operating: 0 °C to 50°C
Quick Charging: 10°C to 40°C
Trickle Charging: 10°C to 45°C
Storage: -40°C to 60°C
Performing a Refresh Cycles every 3 months, will
contribute to the lifetime of the Battery Pack.
To prevent damage to Equipment or Battery:
Fully charge before use.
Keep the battery cool
Do not dispose in open fire
Observe polarity
Do not solder directly to the cells
Do not short circuit
Store Batteries outside the Instrument