Filter
Top Products
Model 16 English Instruction Sheet
Page
4
W
V
•
Check
If a dc or ac voltage greater than about 4.5V is present across the inputs
when the meter is set to
R, G, or e, the meter switches automatically
to dc or ac voltage mode (V•Check mode).
W Warning
Repetitive transients on a dc bus will cause V•Check to
select ac volts, even though a hazardous dc voltage may
be present. To avoid a misleading display and possible
electric shock, manually select the proper volts function
for measurements on these circuits.
When V•Check is activated, the meter has low input impedance (LoZ)
≅2 kΩ. This load can alter the voltages in electronic control circuits. Do
not use V•Check to measure voltage in circuits that could be damaged by
a 2 kΩ load.
Hint: V•Check can be effectively used to eliminate “ghost” voltages.
16
MULTIMETER
OFF
600V
COM
CAT
+
A
TEMPERATURE
V
•
Check
or
If AC detected
If DC detected
Meter puts 2 kΩ
load on circuit.
Disable and re-enable V•Check
For , and Ω,
Disables V•Check and
locks meter in selected
mode.
2 sec
or
or
Re-enables
V•Check
ip09i.eps