Fujitsu MHV2080BH Saw User Manual


 
Removal and Replacement Procedure
2-2 C141-F074
2.1 Spare Parts
See Table 2.1 for the model and parts numbers to order the replacement disk drive.
Table 2.1 Model and parts numbers
Model Name
Capacity
(user area)
Mounting screw Order No.
MHV2100BH 100 GB M3 Depth 3 CA06672-B140
MHV2080BH 80 GB M3 Depth 3 CA06672-B148
MHV2060BH 60 GB M3 Depth 3 CA06672-B136
MHV2040BH 40 GB M3 Depth 3 CA06672-B124
2.2 Disk Drive Removal
The method and procedures to demount the disk drive to check the jumper
terminal, change the jumper position, or replace the device differ depend on the
system cabinet structure. Therefore, for actual working procedures, the specific
conditions necessary for each system must be determined. The general removal
procedures, with notes, are as follows.
a) Disconnect the power-interface cable.
b) Remove the screws that attach the drive and remove the drive from the
system cabinet.
c) When storing or transporting the drive, pack it an antistatic bag in
compliance with section 1.1.2 (5) d. and (5) e..
To protect the device from damage and prevent the worker getting hurt, observe
the following cautions and precautions in Subsection 1.1.1.
Damage or Device damage
1. Perform any removal after the system power is completely
disconnected. The cable must not be disconnected and the
screws that attach the drive must not be removed with the
power ON.
2. Do not move the drive and attach or detach the connector until
it comes to a complete stop (about 30 s after the power is
turned OFF).
3. Perform the human body grounding to discharge any static
electricity from your body. (Be sure to wear a wrist strap)