Genesis Advanced Technologies GMT15A Cordless Sander User Manual


  Open as PDF
of 12
 
English
Multi-Purpose Oscillating Tool
Operator’s Manual GMT15A
ASSEMBLY AND ADJUSTMENTS
WARNING: Always be sure that the tool is switched off and unplugged before adjusting, adding
accessories, or checking a function on the tool
To install the saw blade or scraper blade
 
 

 

NOTE:Some accessories, such as a saw blade, may be mounted either straight on the tool, or at an angle to
enhance usability. Always make sure the 4 pins are engaged as in step 2 above.
To install the Sanding pad and Sandpaper
 
 

 
 

NOTE:For maximum sandpaper life, rotate the pad or sandpaper 120 degrees when tip of sandpaper becomes worn.
WARNING: DO NOT tighten the cap screw unless the accessory is properly seated on the shaft flange.
To remove accessories from the tool, simply just reverse the above procedures.
OPERATION
WARNING:Always be sure the tool is disconnected from the power source before making any adjustments or
setting up prior to cutting. Failure to disconnect or unplug the tool may cause accidental starting, resulting in serious
personal injury.
STARTING AND STOPPING THE OSCILLATING TOOL
To start the oscillating tool
To stop the oscillating tool
FIG 1
a
b
c
a
8
7
FIG 2
 previous next