Filter
Top Products
11
5. Carefully remove the reflector and bulb assembly (fig. G).
6. Disconnect the bulb wire from the red power wire (fig. H).
7. Unsnap the hairpin retaining wires from the reflector’s flange
(fig. I).
8. Using the screwdriver, loosen the retaining screw to remove
the bulb from the reflector (no need to completely remove this
screw).
9. Lift out the bulb and the attached wire (fig. J).
10. Insert the replacement bulb into the reflector’s flange.
11. Put back and secure the hairpin retaining wires (fig. K).
12. Connect the white bulb power wire to the red power wire
(fig. L).
13. Tighten the retaining screw on the flange (fig. M).
14. Reassemble in reverse order.
15. Operate switch to ensure proper operation of spotlight
(fig. N).
Replacing the battery pack
The Sealed Lead Acid Battery has a life of several years, if
recharged promptly after each use. When a fully charged battery
only provides about five minutes or less of spotlight operation, it
should be replaced with a new one.
To replace the battery you will need the GMC Part VEC117-AUBAT.
WARNING. DO NOT ALLOW BARE CONNECTORS TO
CONTACT EACH OTHER DANGEROUS SPARKING
CAN OCCUR.
NOTE. WHICH WIRES ARE ON THE BATTERY TERMINALS
CAUTION. Incorrectly connected wires will not allow the spotlight
to operate. Incorrect battery polarity will damage the circuits inside
the spotlight. Double check battery polarity before reassembly!
G
H
I
J
K
L
M
N