Filter
Top Products
11
tighten on the drill bit. The front section of the chuck
needs to be tightened firmly to ensure the drill bit is
held securely.
4. To remove the drill bit, hold the rear section of the
chuck firmly and rotate sharply the front section of the
chuck in a anti-clockwise direction, sufficiently enough
to allow the drill bit to be removed.
Adjustable side handle
1. Turn the side handle clamp
knob (6) anti-clockwise
to loosen the collar fully and
slip it over the chuck (1) onto
the drill.
2. Adjust the position of the
side handle (5) to suit the
application and tighten the
side handle clamp knob (6)
to secure it in place.
Drilling
Drilling metals
• Always clamp sheet metal.
• Support thin metal with a block of wood to avoid
distorting it.
• Use a punch to mark the centre of the hole.
• Use a suitable lubricant for the material you are
working on,
USE: FOR:
Oil Steel
Turpentine or paraffin Aluminium
Do not lubricate Brass, copper or cast iron
Drilling plastics and plastic coated chipboard
• Use high speed drill bits
• See drilling wood below
Drilling masonry
• This drill is not designed for drilling masonry. Purchase
or hire a Hammer drill.
Drilling wood
• Clamp a piece of scrap wood to the back of your work to
prevent splintering.
All drilling operations
• Mark off the centre of the hole using a centre punch
or nail.
• Don’t force the drill, let it work at its own pace
• Keep the drill bit sharp.
• Reduce pressure, as the drill is about to break through
the item being drilled.
Chuck replacement
The chucks of reversible drills are always fixed by a screw
with a left-hand thread. The screw, which is located in the
centre of the chuck, must be removed before the chuck can
be removed. To remove the screw, turn it in a clockwise
direction. The chuck can now be removed by unscrewing it
anti-clockwise. If you have trouble removing the chuck take
the drill to your nearest authorised service centre for chuck
replacement.
Caution. Always ensure that the drill is switched off
and the battery pack is removed before making any
adjustments.
Maintenance
• Store the tools, instruction manual and where necessary
the accessories in the original packaging. In this way
you will always have all the information and parts ready
to hand.
• Do not throw used batteries into fire or water. There is
a danger of explosion! Please hand in non-working or
used batteries, or tools with built-in batteries, to the
environmentally-safe disposal unit at a municipal waste-
disposal centre, or to your dealer.