Global Machinery Company 243T Drill User Manual


 
7
charging the exact type of rechargeable battery pack as
supplied with the charger.Any other use may result in
the risk of fire, electric shock or electrocution.
The charger and battery packs supplied with it are
specifically designed to work together. Do not attempt
to charge the battery pack with any other charger than
the one supplied.
Do not place any object on top of the charger as it
could cause overheating. Do not place the charger near
any heat source.
Do not pull on the lead of the charger to disconnect it
from the power source.
Make sure that the charger cable is positioned where
it will not be stepped on, tripped over or otherwise
subjected to damage or stress.
Do not use an extension cord unless it is absolutely
necessary. The use of an improper extension cord could
cause the risk of fire, electric shock or electrocution.
Do not use the charger if it has been subjected to a
heavy knock, dropped or otherwise damaged in any
way. Take the charger to an authorised service centre
for a check or repair.
Do not disassemble the charger. Take it to an
authorised service centre when service or repair is
required. Incorrect re-assembly may result in the risk of
fire, electric shock or electrocution.
To reduce the risk of an electric shock, unplug the
charger from the power supply before attempting to
clean it. Removing the battery alone does not reduce
the risk.
Never attempt to connect two chargers together.
Do not store or use the tool and battery pack in
locations where the temperature may reach or exceed
104°F (40°C) such as alongside sheds or metal
structures in the summer.
The charger is designed for use from a standard
household electrical supply (230–240 volts). Do not
attempt to connect the charger to a supply with a
different supply.
If you wish to charge a second battery pack, unplug
the charger from the mains supply and leave it for at
least 15 minutes. After this time you can charge a
second battery pack.
Additional safety instructions for the
battery pack
The battery pack for this tool has been shipped in a low
charge condition.You should charge the battery pack
fully before use.
To ensure the longest battery life and best battery
performance, always charge the battery when the air
temperature is between 18–24°C. Do not charge the
battery pack when the temperature is below 0°C, or
above 40°C. This is important. Failure to observe this
safety rule could cause serious damage to the battery
pack.
Do not incinerate the battery pack even if it is seriously
damaged or can no longer hold a charge. The battery
pack can explode in a fire.
Never attempt to open the battery pack for any reason.
If the plastic housing of the battery pack breaks open
or cracks, immediately discontinue its use and do not
recharge it.
The battery pack utilizes nickel-cadmium cells.
Cadmium is considered to be a toxic material. Use an
environmentally safe disposal unit at a municipal
waste disposal centre to dispose of a damaged or worn
out battery.