Filter
Top Products
9
Unpacking
Due to modern mass production techniques, it is unlikely
that your GMC Power Tool is faulty or that a part is missing.
If you find anything wrong, do not operate the tool until the
parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
Assembly
Wheels
Fitting the wheels
Note. In order to fit the wheels the following supplied
accessories are required:
1. To fit the wheels (12) first insert the wheel bolt through
the wheel.
2. Fit the wheel assembly through the hole in the bracket
under the tank.
3. Select one of the provided washers and nuts.
Slide the washer onto the wheel bolt then proceed to
screw on the nut.
4. Completely tighten the nut from the underside of the
wheel with spanner while holding the outer side nut
with another spanner.
5. Repeat for the second wheel.
Handle
The handle of the compressor must be fitted in the
following manner:
Note. In order to fit the
handle the following supplied
accessories are required:
1. Insert the handle into the
inside walls on the brackets
which have been welded onto
the tank.
2. Align the holes of the handle
and the bracket.
3. Select one of the hex head
bolts and one washers
depicted above.
Slide the washer under the head of the hex head bolt
and insert the assembly into one of the fixing holes.
Note. Make sure that the bolt slots through both the handle
and the welded bracket holes.
4. Using your hands fit the nut to the threaded end of the
bolt. Screw together until it is hand tight.
5. Repeat the above process for the remaining three holes.
6. Once all four bolts have
been hand tighten select the
provided Allen key and a
spanner or socket and go over
the four bolts, ensuring that
they are tightly secured.
Nut
Bracket
Wheel
Wheel bolt
Washer