Global Machinery Company ATI2K Impact Driver User Manual


 
13
Troubleshooting (cont.)
Trouble Possible cause(s) Suggested remedy(s)
Moisture blowing out of
tool.
1. Water in tank. 1. Drain tank. Oil tool and run until no
water is evident.
2. Water in air hoses. 2. a. Install a water filter.
b. Install an air dryer.
Impacts slowly or will not
impact.
1. Lack of lubrication. 1. Lubricate the air motor and impact
mechanism.
2. Tool regulator set in wrong position. 2. Adjust the regulator on the tool to
the maximum setting.
3. Inline regulator too low. 3. Adjust regulators in the air system.
Impacts rapidly but will
not remove bolts.
1. Worn impact mechanism. 1. a. Replace worn impact
mechanism components.
b. Return impact wrench for repair.
Does not impact.
1. Broken impact mechanism. 1. a. Replace broken impact
mechanism components.
b. Return impact wrench for repair.