Filter
Top Products
5
Additional safety rules
for bench grinder stands
WARNING! DO NOT fit the bench grinder to the stand
until the stand is bolted through or into the floor. This stand
is not designed to be a free standing stand, and the base
must be secured to the floor or area where the stand will
be positioned. Do not fit the grinder or operate the grinder
without the base being firmly attached as it will tip over.
Additional safety rules for bench grinders
• Replace cracked wheel immediately.
• Always use guards and eye shields.
• Do not overtighten wheel nut.
• Use only flanges furnished with the grinder.
• Adjust distance between wheel and work rest to maintain
1/16 inch or less separation as the diameter of the wheel
decreases with use.
• Frequently clean grinding dust from beneath grinder.
• Always remove the plug from the mains socket before
making any adjustments or maintenance, including
changing the wheel.
• Always wear eye protection and check that the eye
shields on the grinder are properly adjusted.
• Always turn the grinder off when it is not in use and
never leave it unattended without first switching off and
removing the power plug. Never leave the grinder until
the grinding wheels have come to a complete stop.
• Make sure that any replacement wheel is rated at
3400RPM or higher.
• Do not let anyone under 18 years operate this tool.
• Rags, cloths, cord, string and the like should never be left
around the work area.
• If you are interrupted when operating the tool, complete
the process and switch off before looking up.
• Periodically check that all nuts, bolts and other fixings are
properly tightened.
• Do not use a wheel that has received a blow, especially
to the side of the wheel.
• Replace a cracked or suspect wheel.
• Always allow a new wheel to run for a few minutes at full
speed before using it. Stand to one side at start up.
• Check that the wheel rotates freely each time before
start up.
• Do not use the grinder unless all the guards are properly
fitted and secure.
• Check that the tool rests are properly adjusted before
commencing use.
• Do not overload the grinder. Allow the grinder to run at
full speed, or close to full speed during use.
• Never apply excessive pressure to the wheel. It might
shatter causing personal injury.
• Make sure that the wheel is not in contact with the work
when you start the grinder.
• When using the grinder, use safety equipment including
safety goggles or shield, ear protection, dust mask and
protective clothing including safety gloves.
Wear safety goggles
Wear ear protection
Wear a breathing mask