Filter
Top Products
7
Operation
The GMC 8 litre vacuum/dust extraction system comes
assembled and ready for use.
The filter must always be in the correct position to reduce
the risk of leaks and possible damage to the vacuum.
Ensure that the filter is completely covering the filter cage
and that the filter bag clip (6b) is as close to the lid as
possible. Ensure there are no gaps between the filter and
the lid. It is very important to assemble the filter to the cage
without allowing any possible leaks or tears. Any leaks will
allow the picked up debris to be blown out of the blower port
and back into the surrounding environment.
When using your vacuum to pick up very fine dust, it will
be necessary for you to empty the dust drum and clean or
replace the filter at more frequent intervals to maintain peak
vacuum performance.
Use as a Vacuum
Vacuuming tips
• For crevices, corners etc.,
use the crevice nozzle (11)
• For upholstered furniture use
the upholstery nozzle (13)
• For curtains, lightweight
fabrics etc., use the
upholstery nozzle (13)
• For frames, bookshelves etc.,
use the dusting brush (12)
1. Insert the hose into the
vacuum port (2) and attach
the appropriate nozzle.
2. Unwind the power cord fully
and connect it to the power
point or an extension lead.
3. To turn the unit on push
the ‘on/off’ switch (10) to
the ‘I’ position.
4. To turn the unit off push
the ‘on/off’ switch to the
‘O’ position.
Use as a dust
extraction unit
Your GMC Vacuum can also be
used as a dust extraction unit.
Note. Do not use this unit for
picking up hazardous dust.
1. Locate the vacuum port (2)
on your vacuum.
2. Insert the hose into the vacuum port.
3. Attach the other end on the hose onto the dust extraction
port on the power tool.
4. Turn the vacuum on by pushing the ‘on/off’ switch to the
‘I’ position.