Filter
Top Products
Common Procedures
10 3A1698F
Setting Hi/Lo Switch
(Motor Speed)
1. To extend battery life, try spraying with low motor
speed to get an acceptable spray pattern.
2. Shift to high speed if needed to achieve an accept-
able spray pattern.
Adjusting Pressure
1. To reduce overspray, always spray at lowest pres-
sure that results in an acceptable spray pattern.
2. Spray test pattern and adjust pressure to get
desired coverage.
3. With some materials, if pressure is set too low, no
material may spray out. Turn pressure control up.
Speed Control
Switch
ti16731a
Low Speed
High Speed
Minimum Pressure Setting
Maximum Pressure Setting
ti16705a
ti16704a