Graco 24H404 Glue Gun User Manual


 
Service
4 309032L
Service
Refer to Parts Drawing, page 5, for following instruc-
tions.
Disassembly
1. Relieve the pressure. See Pressure Relief Proce-
dure on page 3.
2. Check all parts thoroughly when disassembling and
carefully replace any worn or damaged parts.
3. Remove bottom seat adapter (10) from grease fun
body (9).
4. Remove acorn nuts (1) and bolts (17) from trigger
guard (12). Remove trigger guard (12).
5. Remove outlet adapter (7).
6. Remove hex nuts (5).
7. Remove yoke (16).
8. Remove rod guide (18) from grease gun body (9).
9. Push plunger rod (15) through seal (4). Be careful;
seat (14), ball (2), and copper gasket (6) will fall out
bottom.
10. Replace all parts included in service kit 243446.
11. Reassemble valve.
12. With trigger in free position tighten bottom nut (5)
until yoke bottoms out on rod guide (this is the max-
imum flow setting. (F
IG. 1) Back off nut approxi-
mately 1/8 turn. Hold bottom nut in place and
securely tighten top nut.
13. If additional adjustment is desired, follow adjustment
procedure on page 3.
14. For specific operational problems, see Trouble
Shooting.
Troubleshooting
To reduce the risk of serious injury after servicing
valve, always make sure the valve is in the closed
position with trigger released.
Problem Cause Solution
Grease Flows with trigger release
Damaged Ball Install Service Kit
Damaged Seat Install Service Kit
Out of Adjustment Readjust, see Adjustment, page 3
Missing Ball Install Service Kit
No grease flow when trigger pulled
Out of Adjustment Readjust, see Adjustment, page 3
Plugged Seat Clean seat
Disassembled Plunger and Rod Reassemble
Grease is leaking out of bottom of gun
Loose Bottom Adapter Tighten adapter (F
IG. 1)
Missing Copper Gasket Install Service Kit
Worn Copper Gasket Install Service Kit
Grease is leaking out of the top of gun Worn Seal in top of gun Install Service Kit
Short seal life Worn plunger rod Install Service Kit
Trigger will not move
Bent guard Replace guard
Bent pivot pin Install Service Kit
Damaged handle Replace trigger