Setup
8 3A0153E
Setup
Suction Tube Selection
This sprayer comes with two different suction tubes.
Standard Suction Tube (sprays ceilings and walls):
When spraying walls, the inlet of the suction tube should
be aimed at the front of the material cup.
When spraying ceilings, the inlet of the suction tube
should be aimed at the back of the material cup
(towards the trigger).
Specialized Suction Tube (sprays floors):
When spraying floors, the inlet of the suction tube
should be aimed at the front of the material cup (towards
Spray Tip/Guard Assembly).
NOTE: If the sprayer is angled or tilted too far, the
suction tube will lose contact with the material and
the sprayer will stop spraying.
Use only water-based or oil-based (mineral
spirit-type) materials with flash point greater than
100° F (38° C). Do not use materials which state
“FLAMMABLE” on the packaging. For more information
about your material, request MSDS from distributor or
retailer.
Spraying certain materials may cause static
build-up in the sprayer that can result in static
shock to the user. If this occurs, first ensure the mate-
rial has a flash point greater than 100° F (38° C) and
does not state that it is FLAMMABLE anywhere on the
package. If still feeling a static shock, the material likely
contains a non-mineral spirits fluid such as, but not lim-
ited to, xylene, toluene, or naphtha, which can build up
static. Switch to an alternative material.
Use oil-based material outdoors or in a well-ventilated
indoor area with a flow of fresh air.
Keep spray area well-ventilated. Keep a good supply
of fresh air moving through the area.
NOTICE
Your sprayer is NOT compatible with harsh cleaners
such as chlorine bleach. Using these cleaners will
cause damage to the sprayer.
ti15476a
ti15475a
ti15477a
ti15511a