Filter
Top Products
Shutdown and Cleaning
16 3A0159E
Shutdown and Cleaning
Flushing Sprayer
1. Engage trigger lock and pull control lever UP to
release pressure.
2. Remove material cup and properly dispose cup liner
or excess material.
3. Remove and clean sprayer intake tube and screen
with water (or flushing fluid) and a brush every time
you flush the sprayer. Reconnect intake tube.
4. Clean cup if not using a liner, and fill with water or
appropriate flushing fluid.
5. Reconnect material cup and shake sprayer to move
clean water around and clean all areas inside of
cup and underside of sprayer.
6. Disengage trigger lock and trigger sprayer for
approximately 15 seconds. Engage trigger lock.
NOTICE
Failure to properly clean sprayer after each use will result
in hardened materials, damage to the sprayer, and the
warranty will no longer be valid.
Use only water-based or oil-based (mineral
spirit-type) materials with flash point greater than
100° F (38° C). Do not use materials which state
“FLAMMABLE” on the packaging. For more
information about your material, request MSDS
from distributor or retailer.
Use oil-based material outdoors or in a well-ventilated
indoor area with a flow of fresh air.
Keep spray area well-ventilated. Keep a good supply
of fresh air moving through the area.
NOTICE
Protect the internal parts of this sprayer from water.
Do not submerge the sprayer in cleaning fluid. Openings
in shroud allow cooling of mechanical parts and electron-
ics inside. If water gets into these openings, the sprayer
could malfunction or become permanently damaged.
ti14994a
ti14999a
ti15002a
ti15001a
ti15441a
ti14994a