Graco 262854 Paint Sprayer User Manual


 
Service
12 3A2799A
7. Position the trigger (24) on the gun body. Insert the
pivot pin (23) into the top hole (A) and secure with
the screw (13) on the other side. Ensure there is an
e-clip (26) on one end of the trigger pin (18). Slide
the pin through lower trigger holes and through the
slot (B) in the spring guide (16) -- turn the spring
guide to align, as needed. Install the other
e-clip (26) onto pin. See FIG.17.
8. If it was removed, install the spring tension screw
(21) at the rear of the gun. Then turn the screw in
until it stops. See FIG.18.
Test the Gun After Service
1. Lock the gun trigger lock. Connect a hose to the
gun. Start and prime the pump.
2. Release the gun trigger lock. Trigger the gun into a
waste container until fluid dispenses. Release the
trigger to be sure the gun immediately stops spray-
ing and that there are no leaks in any gun connec-
tions.
3. Lock the gun trigger lock.
4. Install the tip guard (9) before regular use. See FIG.
19.
FIG.17
FIG.18
18
13
24
26
23
A
B,16
ti19271a
26
21
ti19281a
FIG.19
9
ti19264a