Filter
Top Products
Accessories
26 311053H
Accessories
Gun Manifolds
Order separately; not included with gun.
(See Parts, page 22.)
Part No. 241161
North America Manifold
Part No. 241162
International Manifold
Part No. 244930
High Flow Ambient or Temperature Conditioned Mani-
fold for streaming or spraying.
Grounding Clamp and Wire 222011
High Pressure Ball Valves, Fluoroelastomer
Seals
5000 psi (34 MPa, 345 bar) Maximum Working Pressure
Can be used as fluid drain valve.
Bleed-type Master Air Valve
300 psi (2.1 MPa, 21 bar) Maximum Working Pressure
Relieves air trapped in the air line between the pump air
inlet and this valve when closed.
Gasket Filter
Gasket filter 288201, package of 10. Small filter can be
installed in the inlet gasket (3) for added filtration.
Tube Fittings for Air or Water
250 psi (1.7 MPa, 17 bar) Maximum Working Pressure
160° F (71° C) temperature rating
Brush 101892
For cleaning the gun.
In-line Fluid Filter 210500
5000 psi (35 MPa, 350 bar) Maximum Working Pressure
100 mesh. Fits onto the gun's fluid connector. 1/4-18
npsm. Includes the parts shown below.
Needle/Diffuser Options
Needles must be used only with the specified seat to
guarantee proper seating and life.
• Standard viscosity/standard flow
• Fluid Needle 24B916, 3/16 in. carbide ball
• Seat 288196
• Acid catalyzed materials/very low viscosity
materials
• Fluid Needle 241468, 3/16 in. plastic ball
• Seat 288196
Temperature Sensor and Cable
For temperature conditioned manifold
Part No. Description
210657 1/2 npt(m)
210658 3/8 npt(m)
210659 3/8 x1/4 npt(m)
Part No. Description
107141 3/4 npt(m x f) inlet and outlet
107142 1/2 npt(m x f) inlet and outlet
Part No. Length
104172 1/8 npt(m) x 1/4 OD tube
597151 1/8 npt(m) x 1/4 OD tube, 90° elbow (swivel)
F
IG. 18: In-line Fluid Filter
Part No. Length
198457 RTD Sensor, 100 ohm, 1/8 npt(m) with 3 pin
Picofast connector
198458 RTD cable, 6 ft. (1.83 m) Flex cable to St.
Clair connector
210501
164075
Filter
168517
205264
}