Filter
Top Products
Cleanup
14 332156B
12. Raise siphon tube above flushing fluid and run
sprayer for 15 to 30 seconds to drain fluid.
13. Turn pump valve OFF. Turn engine OFF.
Caution: If flushing with water, do not leave water in
sprayer. Flush again with mineral spirits, oil or Pump
Armor and leave this protective coating in the sprayer to
help prevent freezing or corrosion and increase sprayer
life.
14. Rotate handle clockwise to close prime valve. Trig-
ger gun into flushing pail to purge fluid from hose.
15. Rotate handle counter-clockwise to open prime
valve.
16. If pump includes filter, install filter into filter bowl.
Make sure plastic center tube is tightened securely.
Hand tighten filter bowl. Hand tighten gun handle.
17. Clean tip, guard and gasket with a soft bristle brush
to prevent part failure due to dried materials.
Assemble parts and attach loosely onto gun. Wipe
sprayer, hose and gun with a rag soaked in water or
mineral spirits.
ti20729a
ti5261a
OFF
ON
START
ti7108a
Pump Armor
ti2895a
ti21060a
ti7129b
ti20730a
ti21061a
ti7120b
ti20790a
ti5276a
Artfile #: ti5276a
Description: GH 200 230 300 330 OPERATION 233940 248559-64
Scale: -
Artist: J. Iverson