Graco H40 Paint Sprayer User Manual


 
Startup
312062W 31
h. Use feed pumps to load system. Hold
gun fluid manifold over two grounded
waste containers. Open fluid valves A
and B until clean, air-free fluid comes
from valves. Close valves.
8. Set temperatures
a. Turn main power ON .
b. Press or to change tem-
perature scale.
c. Press to display target tempera-
tures.
d. To set heat zone target tempera-
ture, press or until display
shows desired temperature. Repeat for
and zones.
Do not mix components A and B during
startup. Always provide two grounded waste
containers to keep component A and compo-
nent B fluids separate.
ti2484a
°
F
°
C
A
B
Temperature Controls and Indicators, see
page 18
This equipment is used with heated fluid,
which can cause equipment surfaces to
become very hot. To avoid severe burns:
Do not touch hot fluid or equipment.
Allow equipment to cool completely
before touching it.
Wear gloves if fluid temperature exceeds
110°F (43°C).
For zone only, if FTS is discon-
nected at startup, display will show hose
current (0A). See step j, page 32.
°
F
°
C
A
B