Filter
Top Products
Warnings
4
CAUTION
Water or material remaining in unit when temperatures are below freezing can damage
motor and/or delay pump startup.
To insure water and material are completely drained out of unit:
1. Remove material line from sprayer.
2. Tip sprayer up as shown.
Before adding material or starting unit in cold weather, run warm water through pump.
Before adding material to hopper, install burp guard (J). When only a small amount of
material remains in the hopper, the burp guard prevents material from shooting out
when the unit is turned off. This material could splash in the operator’s eyes or on skin,
or into the air.
ti9075a
ti8376a
J