Filter
Top Products
308-230 5
Installation
Assembling the Wall Mount Unit
Install
the wall bracket (2) 5 ft (1.52 m) above the floor
.
Use the mounting hole layout shown on page 18. Be
sure the wall is strong enough to support the weight of
the pump and hoses, any accessories, the fluid, and
stress caused by pump operation.
The following steps apply to Model 236–414 only:
Apply thread sealant and screw the connector (28) into
the pump’
s fluid inlet. See Fig. 2.
Slide the bung plug (31) onto the suction tube (33).
Push the 0.625 in. (16 mm) OD suction tube into the
elbow (30) to its full depth, then tighten the nut secure
-
ly with a wrench.
Push the 0.5 in. (13 mm) OD flexible tube (29) into the
elbow (30) to its full depth, then tighten the nut secure
-
ly with a wrench. Push the other end of the flexible
tube into the connector (28) to its full depth, then tight
-
en the nut securely with a wrench.
Screw the bung plug (31) into the drum bung opening.
Adjust the suction tube (33) so the end of the tube is
about 1/2 in. (13 mm) of
f the bottom of the drum, and
secure using the thumbscrew (32).
02773
Fig. 2
Apply
thread sealant to male threads.
1
3
2
Insert
tube
(33) into elbow (30) to
full
depth and tighten nut
securely with wrench.
Insert tube (29) into connector (28)
to full depth and tighten nut
securely with wrench.
2
28
29
30
33
31
32
1
3
2
22