Filter
Top Products
308491 13
Service
0473
2
29
28
27
18
25
Fig. 20
A
B,16
8. Position the trigger (25) on the gun body. Insert the
pivot pin (28) into the top hole (A) and se cure with
the screw (29) on the other side. Place an e-clip
(27) on one end of the trigger pin (18). Slide the
pin through lower trigger holes and through the slot
(B) in the spring guide (16) (turn the spring guide
to align, as needed). Install the other e-clip (27).
See Fig. 20.
Fig. 21
1
21
Turn in until screw
stops
1
03980
9. If it was removed, install the spring tension screw
(21) at the rear of the gun. Then, turn the screw in
until it stops. See Fig. 21.
Test the Gun Before Regular Use
1. Lock the gun trigger safety. Connect a hose to the
gun. Start and prime the pump.
2. Release the gun trigger safety. Trigger the gun into
a waste container. Release the trigger to be sure
the gun immediately stops spraying and that there
arenoleaks.
3. If the gun has a d if fuser, check the diffuser using
the procedure on page 9.
4. Install the tip guard (30) before regular use.
See Fig. 22.
Fig. 22
03965
30