Filter
Top Products
Spraying
Techniques
Prolonged Overhead or Downward Spraying with a
Cup
For
prolonged overhead spraying, loosen the fluid
tube nut
(N)
and turn the entire cup assembly one-
half turn. See Fig.
15.
This will position the fluid tube
(36) in the back side of the cup
so
the entire contents
I
will be sprayed.
36
Fig.
15
Forpro/onged downwafd spraying, make sure the
fluid tube (36)
is
positioned
as
shown in Fig. 16.
W2
Flg.
16
Turbine Filter Maintenance
The turbine systems are lifetime lubricated. The only
maintenance required is filter cleaning and replace
ment.
The turbine main filter and pre-filter must be clean at
all times
to
provide sufficient air flow to cool the motol
and atomize the fluid. Check the filters weekly, mini-
mum. Replace the prefilter as required.
NOTE
To
check the filter, turn on the turbine and
the air intake holds the paper in place, the filter
is
place a piece of paper against the air intake filter.
If
okay.
To
clean the main filter:
1.
Turn
off
and unplug the turbine.
2.
Loosen the four main filter screws.
3.
Remove the main filter and clean it by following
one of the following three methods:
0
Tap the filter gently on a flat surface, dirty side
down.
0
Direct compressed air
(100
psi
[7
bar] maxi-
direction of the arrows on the side of the filter.
mum) through the filter panel in the opposite
0
Soak the filter for
15
minutes in water and a
Air dry the filter; do not use compressed air.
mild detergent. Rinse the filter until it
is
clean.
-
WARNING
To avoid damage
to
the turbine and possible elec-
tric shock, never install a damp filter in the turbine.
Maintenance continued on
next
page.
308-336
13