Filter
Top Products
309162 3
WARNING
SKIN INJECTION HAZARD
Spray from the gun, hose leaks, or ruptured components can inject fluid into your body and cause
extremely serious injury, including the need for amputation. Fluid splashed in the eyes or on the skin
can also cause serious injury.
D Fluid injected into the skin might look like just a cut, but it is a serious injury. Get immediate medi-
cal attention.
D Do not point the gun at anyone or at any part of the body.
D Do not put your hand or fingers over the dispense tip.
D Do not stop or deflect leaks with your hand, body, glove or rag.
D Tighten all connections before operating the equipment.
D Check the hoses, tubes, and couplings daily. Replace worn, damaged, or loose parts immediately.
Permanently coupled hoses cannot be repaired; replace the entire hose.
D Use only Graco approved hoses. Do not remove any spring guard that is used to help protect the
hose from rupture caused by kinks or bends near the couplings.
FIRE AND EXPLOSION HAZARD
D If there is any static sparking or you feel an electric shock while using this equipment, stop dis-
pensing immediately. Do not use the equipment until you identify and correct the problem.
D Keep the dispensing area free of debris, including solvent, rags, and gasoline.
D Electrically disconnect all equipment in the dispensing area.
D Extinguish all open flames or pilot lights in the dispensing area.
D Do not smoke in the dispensing area.
D Do not turn on or off any light switch in the dispensing area while operating or if fumes are present.
D Do not operate a gasoline engine in the dispensing area.
TOXIC MATERIAL HAZARD
Hazardous material or toxic fumes can cause serious injury or death if splashed in the eyes or on the
skin, inhaled, or swallowed.
D Know the specific hazards of the product you are using.
D Store hazardous material in an approved container. Dispose of hazardous material according to all
local, state and national guidelines.
D Always wear protective eyewear, gloves, clothing and respirator as recommended by the material
manufacturer.