Filter
Top Products
5307616
Component Identification
9089d
HYDRAULIC SUPPLY LINE TO MOTOR
HYDRAULIC
RESERVOIR
GASOLINE
FILL CAP
MOTOR RESET BUTTON
HYDRAULIC MOTOR
HYDRAULIC
PUMP
SUCTION HOSE
SUCTION TUBE
PRESSURE
CONTROL KNOB
OUTLET
FITTING
DISPLACEMENT PUMP
HYDRAULIC RETURN LINE TO MOTOR
PRESSURE
DRAIN VALVE
Fig 1
Setup
1. Connect the Hose and Gun
a. Remove the plastic cap plug from the outlet
tee and screw an accessory, conductive or
grounded spray hose onto the 1/4 npsm(f) out-
let fitting. See Fig 1.
b. Connect a small diameter, 3 ft (0.9 m) whip
hose between the main hose and a spray gun,
if desired, for more flexible gun movement.
c. Don’t use thread sealant on the swiveling nut
of the hose couplings, and don’t install the
spray tip yet.
NOTE: Use thread sealant on all male threads except at
swivel unions. Swivel unions are made to self–
seal, and using thread sealant prevents the
swivel from turning freely.
2. Fill the Packing Nut/Wet Cup 1/3 full with Graco
Throat Seal Liquid (TSL), supplied. See Fig. 2.