Filter
Top Products
Setup
7
Setup
Texture Spraying
1. Connect air hose to user-supplied air compressor &
material hose (G) to material hose outlets.
2. Connect user supplied air hose to gun.
3. Open air valve.
4. Connect material hose to gun.
5. Install spray nozzle. See Recommended Nozzle
Selection Chart, page 10.
6. Fill material hopper with 1 gallon of water.
7. Turn power switch (K) ON (leave compressor OFF).
Important
• To increase pump life, turn power off when not spraying.
• Do not allow material to dry inside pump, hoses, gun or spray system.
• To break in new pump run dry for no more than 2 minutes.
ti8375a
ti8534a
ti8528a
To break in new pump run dry fro no more than 2
minutes.
ti8705a
ti9774a
ti8372a