Filter
Top Products
-14- H2854 1 H.P. Variable Speed Plunge Router
Figure 13.
Bit centering gauge attachment.
Figure 14.
Edge guide attachment.
Figure 15.
Flush trim guide attachment.
Figure 16.
Circle cutter attachment.
Edge Guide
The edge guide is designed for dado and plow
operations that need to be parallel and equidistant
from a workpiece edge. The maximum distance
from the edge that a dado or plow operation can
be performed is 6 inches.
Flush Trim Guide
The flush trim guide is designed to keep a router
bit flush against a subsurface edge, similar to a bit
with a flush guide bearing. This guide is used
when trimming laminate flush with a subsurface
edge. Adjust the guide so that it is flush with the
cutting edge of the bit and rides along the subsur-
face edge. The router bit and guide follow along
the edge of the subsurface, trimming the laminate
flush. Be sure the guide does not come into con-
tact with the bit.
Circle Cutter
The circle cutter consists of a pivot pin that attach-
es to the edge guide. The edge guide must be
installed in the inverted position as compared to
its position when you are edge routing. Fasten the
pivot bolt to one of the holes located on the cen-
ter of the edge guide. Adjust the pivot bolt so it is
set to the desired height. Place the pivot pin on
the desired center location of the circle. Adjust the
edge guide so that the distance between the
inside edge of the bit and the pivot pin equals the
radius of the desired circle. Set the depth of the
router bit and you are ready to route a circle.
Pivot Bolt