Grizzly C1393-96 Drill User Manual


  Open as PDF
of 2
 
-2-
The process for completing your rail end cuts is
roughly the same as those for your stile and rail
cuts.Themainconcernisensuringthattheamount
ofrevealatthefrontedgeofyourrailmatchesthe
cutsmadeinyourstiles.
Tocompleteyourendrailcuts:
1. Adjustyourrouterand
bit,asdescribed
earlier,
and
make
atest
cut
with
thesur-
plusmate-
rial.
2. Join the test cut with your previous cuts and
checkthejointtodetermineflushness.
3. Re-adjustandre-testuntilyouaresatisfiedwith
yourresults.
4. Whensatisfiedwiththeresultstightentherouter
andcutyourprojectmaterial.
A ball bearing is supplied with these router bits
whichallowtheuseoftemplatesforcurvedwork
asseentotheright.
Usingatemplate:
1. Thetem-
plate
should
bethe
same
sizeas
the
expected
finished
panel.
2. The curved portion of the workpiece should
be rough cut so that no more than
1
⁄8" pro-
trudesbeyondthetemplate.
3. Thefenceandmitermustberemovedwhen
usingatemplate.Astartingpinorblockmust
beinstalledasshowninFigure2.
Always disconnect power to
themachinewhensettingup
or making adjustments.
Failure to dothis may result
inseriouspersonalinjury.
FENCE
Figure2.Startblockfortemplatecutting.
 previous