Grizzly G0509G Lathe User Manual


  Open as PDF
of 92
 
"(+"
<%*%.<%*%.<&+m)%AVi]Z
To install a chuck or faceplate:
1. 9>H8DCC:8IA6I=:;GDBEDL:G
2. EaVXZ V e^ZXZ d[ eanlddY VXgdhh i]Z aVi]Z
lVnhVcYedh^i^dc^i_jhijcYZgi]ZX]jX`#
3. EaVXZi]ZX]jX`dci]ZXgVYaZ#
4. BV`ZhjgZi]ZX]jX`iVeZgVcYhe^cYaZiVeZg
bVi^c\hjg[VXZhVgZeZg[ZXianXaZVc#
5. >cheZXiVcYbV`ZhjgZi]ViVaaXVbadX`hijYh
VgZjcYVbV\ZY! VgZXaZVcVcYa^\]ian d^aZY!
VcYi]Vii]ZXVbadX`hijYXVehXgZlhVgZ^c
eaVXZVcYhcj\#
NOTICE
Never install a chuck or faceplate without
having the camlock cap screws in place
or fully tightened. If you ignore this notice,
once installed the chuck may never be able
to be removed since the camlock studs will
turn with the camlocks and never release.
6. 6a^\c i]Z X]jX`"id"he^cYaZ i^b^c\ bVg`h
Figure 39! VcY ha^YZ i]Z X]jX` dcid i]Z
he^cYaZ#
7. IjgcVXVbadX`l^i]i]ZX]jX``Znjci^ai]Z
XVba^cZ[VaahWZilZZci]ZVbVg`hFigure
38#
Figure 38. 8VbVcYadX`bVg`h#
8VbGZaZVhZ9VijbA^cZ
8Vb
AdX`
BVg`
Kh
8. AdX`i]Zdi]ZgXVbh^cVhiVgeViiZgchdi]Z
X]jX`^hYgVlcjeZkZcandcVaah^YZhl^i]dji
VcnX]VcXZd[b^hVa^\cbZci#
Note:If any of the cam lock marks (Figure 38)
do not fall between the "V" marks when the
cam lock is tight, you must adjust the offend-
ing camlock stud as discussed in Camlock
Stud Adjustment on Page 37.
9. GZbdkZi]ZX]jX``Zn#
 previous next