Grizzly G0514X Saw User Manual


  Open as PDF
of 92
 
<%*&)M"M(B[\#&%$%* !<%*&)M'B[\#)$%, 
"(("
Figure 45.7aVYZ\j^YZXdcigdah#
AViZgVa
6Y_jhibZci
GdY8Ve
HXgZl
@cjgaZY
@cdW
4. AddhZci]ZXVehXgZldci]ZaViZgVaVY_jhi"
bZci gdY VcY VY_jhi i]Z WaVYZ \j^YZh jci^a
i]ZZY\Zhd[i]ZWZVg^c\hVgZ
&
$&+WZ]^cYi]Z
WaVYZ\jaaZihVh^aajhigViZY^cFigure 46#
Note: The
1
/16" spacing is ideal, although with
larger blades it may not be possible. In such
cases, adjust the guide bearings as far for-
ward as possible to the blade gullets, and still
maintain the proper support bearing spacing
adjustment.
7aVYZ
<j^YZ
7ZVg^c\h
7ZVg^c\GdiVi^dc
6Y_jhibZci8Ve
HXgZl
Figure 46.AViZgVaVY_jhibZcid[WaVYZ\j^YZh#
7aVYZ
<jaaZi
3. ;Vb^a^Vg^oZndjghZa[l^i]i]ZWaVYZ\j^YZXdc"
igdahh]dlc^cFigure 45#
NOTICE
Make sure that the blade teeth will not con-
tact the guide bearings when the blade is
against the rear support bearing during the
cut or the blade teeth will be ruined.
5. I^\]iZci]ZXVehXgZldci]ZaViZgVaVY_jhi"
bZcigdY#
6. AddhZci]ZWZVg^c\gdiVi^dcVY_jhibZciXVe
hXgZlh#
7. GdiViZ i]Z `cjgaZY `cdW id edh^i^dc i]Z
WZVg^c\h%#%%)VlVn[gdbi]ZWaVYZ#Note:
0.004" is approximately the thickness of a
dollar bill.
8. I^\]iZci]ZXVehXgZlidadX`i]ZWaVYZ\j^YZ
WZVg^c\h^cedh^i^dc#
9. GZeZVii]^hegdXZYjgZ[dgi]ZadlZg\j^YZh#
NOTICE
Whenever changing a blade or adjusting ten-
sion and tracking, the upper and lower blade
support bearings and guide bearings must
be properly adjusted before cutting opera-
tions.
 previous next