Filter
Top Products
-20-
G0537 Scroll Saw
Always disconnect
power to the machine
before performing ser-
vice adjustments. Failure
to do this may result in
serious personal injury.
!
This section is designed to help the operator with
adjustments that were made at the factory and
that might also need to be made during the life of
the machine.
This section is provided for your convenience—it
is not a substitute for the Grizzly Service
Department. If any adjustments arise that are not
described in this manual, then feel free to call the
Grizzly Service Department at (570) 546-9663.
Similarly, if you are unsure of how to perform any
procedure in this section, the Grizzly Service
Department will be happy to guide you through
the procedures or help in any other way.
To ensure that the table is square:
1. Disconnect the machine from the power
source.
2. Loosen the table tilt knob shown in Figure 18.
Figure 18. Pointer and table tilt knob.
Figure 19. Check the angle with a square.
3. Place a square on the table and against the
blade as shown in Figure 19.
4. Adjust the table until the square and the
blade are parallel.
5. Tighten the table tilt knob, loosen the pointer
shown in Figure 18 and adjust it to 0˚.
Pointer
Table Tilt Knob
Squaring Table
About Service
SECTION 8: SERVICE ADJUSTMENTS