Filter
Top Products
-46-
G0588/G0591 12" Sliding Table Saws
5. Remove the old V-belt set and replace them
with a new V-belt set.
Note: The motor V-belts should always be
replaced as a matched set to ensure maxi
-
mum belt longevity and power transmission.
6. Tighten the tension bolt until the belts deflect
between a
1
⁄4" and a
1
⁄2" when pressed firmly
in the center of each V-belt.
7. Replace the lower blade guard.
8. Close and secure the motor cabinet door.
Note: Re-tension the new V-belts after the
initial 10 hours of use
.
To change the scoring blade arbor flat belt:
1. Disconnect the saw from the power
source!
2. Move the blade tilt to 45˚, raise the main
blade all the way up, and open the motor
cabinet door.
4. Remove the screws that secure the lower
blade guard (
Figure 81) and set the guard in
the bottom of the cabinet.
Figure 81. Lower blade guard removal.
3. Rotate the belt tension arm shown in Figure
82 and slide the flat belt off of the roller.
Spring Arm
Figure 82. Scoring blade belt tension arm.
4. Remove the old flat belt and replace it with a
new flat belt.
5. Close and secure the motor cabinet door.