Filter
Top Products
G0605X/G0606X Extreme Series 12" Table Saw
-21-
Outfeed Table
Components and Hardware Needed: Qty
Outfeed Table
.................................................... 1
Lower Shelf ........................................................
1
Shelf End Plate ..................................................
1
Support Legs .....................................................
2
Lower Shelf Brackets ........................................
2
Fence Tube ........................................................
1
Flange Bolts M8-1.25 x 16 ................................
2
Hex Bolts M6-1 x 12 ..........................................
4
Phillips Head Screws M6-1 x 12 .....................
12
Feet
3
⁄8-16 x 2 .................................................... 2
Hex Nuts M6-1 ..................................................
2
Hex Nuts M8-1.25 .............................................
2
Hex Nuts
3
⁄8-16 .................................................. 2
Flat Washers 6mm .......................................... 16
Flange Bolts M8-1.25 x 12 ................................ 9
To install the outfeed table:
1. Turn the outfeed table upside down and
place it on a level surface.
2. Install the feet, support legs, and shelf end
plate in the same manner as described in
Extension Table instructions.
11. Fasten each support leg to the main exten-
sion table with four Phillips head screws and
flat washers as shown in
Figure 19.
Figure 19. Support leg fastened to main
extension table.
12. Rotate both feet until they touch the ground,
and tighten the hex nuts to secure the feet.
13. Fasten the shelf end plate to the legs with
four Phillips head screws and flat washers as
shown in
Figure 20.
14. Place the shelf brackets between the cabinet
and support legs, and fasten with four M6-1
x 12 hex bolts, four flat washers and two hex
nuts (on the outside) as shown in
Figure 21.
Note:
The flange on the shelf bracket must point
up to ensure proper installation.
15. Place the lower shelf on the brackets.
Figure 20. Installing shelf end plate on extension
table legs.
Figure 21. Shelf brackets installed.
Shelf Bracket
Flange