Filter
Top Products
-20-
G0624 10" Benchtop Lathe
After turning, the workpiece can be sanded, as
shown in Figure 27, and finished (in the same
manner) before removing it from the lathe.
Figure 27. Typical sanding operation.
Sanding/Finishing
Whenever sanding or finishing, move the tool rest
holder out of the way to increase personal safety
and gain adequate working room.
Wrapping the sandpa-
per completely around
the workpiece will pull
your hands into the mov-
ing workpiece and may
cause injury. Never wrap
sandpaper completely
around the workpiece!