Support User Manuals

Grizzly G0679 Sander User Manual

Open as PDF

of 56





Horizontal Table Movement



      

      

      



1.       

     

      Figure

38

Workstops



      

        

    







        





      

        



Table Workstop

1.        

Figure 39

      



     

      



The belt speed on the Model G0679 is 3600

FPM, or over 40 MPH. A workpiece ejected

at this speed could cause serious personal

injury and property damage. Always use the

workstops and be sure they are in the cor-

rect position and secured before using the

machine.

Figure 39. Table workstop.





2.         



 Note: To lock the horizontal table move-

ment, turn the table travel locks

1

⁄3 of a turn

clockwise. To release the horizontal table

movement, turn the table travel locks

1

⁄3 of a

turn counterclockwise. Be careful not to over-

tighten the lock handles. Doing so may cause

damage to the machine.

Figure 38. Horizontal table movement.







previous next