Filter
Top Products
"()"
BdYZa<%+..B[\#H^cXZ+$%.
58. Ha^YZi]ZXgdhhXji[ZcXZV\V^chii]Z.%hide
Wdai!i]ZchZXjgZ^i^ceaVXZWni^\]iZc^c\i]Z
B-"&#'* `cdW l^i] i]Z -bb [ZcYZg lVh]Zg
dci]ZI"Wdai!Vhh]dlc^cFigure 51#
Note: Adjusting the crosscut fence in different
positions will be discussed in the Operations
section later in this manual.
Figure 51.HZXjg^c\i]ZXgdhhXji[ZcXZ#
Dust Collection
DO NOT operate the Model G0699 without an
adequate dust collection system. This saw
creates substantial amounts of wood dust
while operating. Failure to use a dust collec-
tion system can result in short and long-term
respiratory illness.
Required CFM at 5" Dust Port: 615 CFM
Required CFM at 2
1
⁄2" Dust Port: 150 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
To connect the saw to dust collection sys-
tem:
1. HZXjgZ V * Yjhi ]dhZ id i]Z edgi adXViZY
jcYZg i]ZiVWaZ dci]Z aZ[ih^YZ l^i] V]dhZ
XaVbe!Vhh]dlc^cFigure 53#
Figure 53.*YjhiedgiadXVi^dc#
59. BdkZ i]Z XgdhhXji ZmiZch^dc [ZcXZ dji hd
i]VindjXVc^chiVaai]Z[a^e hideVhhZbWa^Zh!
Vhh]dlc^cFigure 52#
Figure 52.8gdhhXji[a^ehideh^chiVaaZY#
;a^eHideh
:miZch^dc
;ZcXZ