Grizzly G0716 Saw User Manual


  Open as PDF
of 52
 
 

Sanding Operation
To surface sand a workpiece:
1. OFF

2. 

3.        
     
 Workpiece Inspection  Page 21 

4. 

5. 

Note: Make this adjustment so that the first
passes will take off just the high spots of the
workpiece.
6.      
ON


7. 



8.      
 
  


9.     
     

Note: If fine thickness dimensioning or main-
taining the same finishes on both sides of
the workpiece is required for the operation,
flip the workpiece over, lower the sanding
drum the correct amount, and repeat Steps
7–9. Return the workpiece to its original side
before continuing with the next step.
10.        
   Steps 7–10  


Note: Keep in mind that as the grit and
desired finish change, you need to reduce the
feed rate.
11. 
OFF
 previous next