Filter
Top Products
-66-
Model G0768/G0769 (Mfd. Since 8/15)
Removing Tooling
Tools Needed Qty
Wrench 8mm ..................................................... 1
Wrench 17mm.................................................... 1
Wrench 25mm ................................................... 1
Brass Hammer .................................................. 1
To remove tooling:
1. DISCONNECT MACHINE FROM POWER!
2. Remove drawbar cap.
3. Loosen drawbar lock nut (see Figure 111) on
previous page.
4. Unthread drawbar from tooling one full rota-
tion.
Note: Do not fully unthread tooling from
drawbar or the drawbar and tool threads
could be damaged in the next step.
Figure 112. Tapping drawbar to unseat tool
taper.
6. Hold onto tooling with one hand and fully
unthread drawbar.
5. Tap top of drawbar with hammer to unseat
taper (see Figure 112).