Filter
Top Products
Model G0768/G0769 (Mfd. Since 8/15)
-65-
Installing / Removing
To o l i n g
Cutting tools are sharp and
can easily cause cutting
injuries. Always protect
your hands with leather
gloves or shop rags when
handling cutting tools.
The Model G0769 includes a
1
⁄2" drill chuck with
MT#2 arbor (see Figure 108).
Figure 108.
1
⁄2" chuck joined with MT#2 arbor.
Installing Tooling
Tools Needed Qty
Wrench 8mm ..................................................... 1
Wrench 17mm.................................................... 1
Wrench 25mm ................................................... 1
To install tooling:
1. DISCONNECT MACHINE FROM POWER!
2. Remove drawbar cap (see Figure 109).
Figure 109. Location of drawbar cap.
Drawbar Cap
3. Insert tooling into spindle until in contacts
drawbar.
4. Working from top, thread drawbar by hand
into tooling until it is snug (see Figure 110).
Figure 110. Threading drawbar into tooling.
5. Tighten drawbar.
Note: Do not overtighten drawbar.
Overtightening makes tool removal difficult
and will damage arbor and threads.
6. Tighten drawbar lock nut, as shown in Figure
111.
7. Re-install drawbar cap.
Figure 111. Tightening drawbar lock nut.
Drawbar
Locknut