Filter
Top Products
G0457 14" Industrial Bandsaw (Mfg. Since 5/11)
-19-
Figure 21. Installed positive stop bolt.
Positive Stop
23. Pull the handle up and place the fence
assembly on the fixed rail as shown in Figure
20.
Figure 20. Correctly installed fence.
24. Push the handle down to lock the fence
assembly in place.
25. Position the resaw fence evenly on the table
and use the locking adjustment handle to lock
it in place.
26. Thread the M8-1.25 hex nut halfway onto the
M8-1.25 x 80 hex bolt (this is the positive stop
bolt).
27. Thread the positive stop bolt into the thread-
ed hole on bandsaw body as shown in Figure
21.
Dust Collection
To connect a dust collection hose:
1. Fit the 4" dust hose over the dust port, as
shown in Figure 22, and secure in place with
a hose clamp.
2. Tug the hose to make sure it does not come
off.
Note: A tight fit is necessary for proper per-
formance.
DO NOT operate the Model G0457 without an
adequate dust collection system. This saw
creates substantial amounts of wood dust
while operating. Failure to use a dust collec-
tion system can result in short and long-term
respiratory illness.
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
Figure 22. Dust hose attached to dust port.