Filter
Top Products
G1012 18" Bandsaw -35-
SECTION 7: MAINTENANCE
V-Belts
To ensure optimum power transmission from the
motor to the blade, the V-belt must be in good
condition and operate under proper tension. The
belts should be checked for cracks, fraying and
wear. Belt tension should be checked at least
every 3 months — more often if the bandsaw is
used daily.
The V-belt is accessed via the bottom cover:
1. Push the center of the V-belt.
2. Note the amount of deflection. Deflection
should be approximately
3
⁄4". See “V-Belt
Adjustment” instructions to adjust.
The table and other non-painted surfaces on the
Model G1012 should be protected against rust
and pitting. Wiping the saw clean after every use
ensures that wood dust is not allowed to trap
moisture against bare metal surfaces.
The table can be kept rust-free with regular appli-
cations of products like Boeshield
®
T-9. For long
term storage you may want to consider products
like Kleen Bore's Rust Guardit™. See the current
Grizzly catalog for more on these products.
Table
Sealed and pre-lubricated ball bearings require
no lubrication for the life of the bearings. All bear-
ings are standard sizes, and replacements can
be purchased from our parts department or bear-
ing supply store.
As for other items on this machine, such as
adjustment controls, an occasional “shot” of light
oil is just about all that is necessary. Before
applying, however, wipe off any sawdust with a
clean cloth, towel or dry paint brush, and spray on
the lubricant. Ensure that oil does not get on the
pulleys or V-belt because it could cause belt dete-
rioration and slipping.
Lubrication
Always be aware of the condition of your band-
saw. Routinely check the condition of the follow-
ing items and repair or replace as necessary:
• Loose mounting bolts
• Worn switch
• Worn or damaged blade
• Worn or damaged support bearings or guide
bearings
Miscellaneous
Always disconnect
power to the machine
when making adjust-
ments. Failure to do this
may result in serious
personal injury.