Filter
Top Products
-14- G1067Z Wood Lathe
The Model G1067Z headstock can be swiveled
180˚ as well as positioned anywhere along the
bed.
1. Loosen the quick release lever by pushing it
down (Figure 13).
2. Move the headstock to the desired position
and re-engage the quick release lever
(Figure 14). Note—The large hex nut under
the headstock will require occasional adjust-
ing to assure proper clamping pressure to
the bed. Turn the hex nut in small increments
to fine tune the clamping pressure.
1. Loosen the quick release lever by pushing it
down.
2. Pull the spring loaded quick release set pin
(Figure 15) and rotate the headstock clock-
wise 90˚ or 180˚.
Figure 13.
Figure 14.
Figure 15.
Quick release lever
Set pin
Headstock
SECTION 3: ADJUSTMENTS