Filter
Top Products
-2-
G1600 Pneumatic Sanding Drum For G1495
Operation
1. DISCONNECT LATHE FROM POWER!
2. Install the sanding drum on the lathe spindle
using the adapter included with the lathe
(Figure 2).
3. Slide the sanding sleeve over the sanding
drum.
4. Use a bicycle pump (or other manual pump)
to inflate the drum until the sanding sleeve is
secure. Do not exceed the 10 PSI maximum
rating.
Figure 2. Mounting drum to shaft.
Operation Tips
• Adjust the pressure in the drum to fine-tune
the firmness of the drum for sanding con
-
tours.
• Always hold the workpiece firmly—the soft
surface of the drum will exert more force
on the workpiece than a traditional sanding
drum.
• Deflate the drum when not in use.
Adapter
Sanding Drum
Lathe Outboard
Spindle
Parts Breakdown & List
REF PART # DESCRIPTION
2 P1600002 RUBBER DRUM 4"
3 P1600003 VALVE STEM
4 PWS002 WOOD SCREW #10 X 1/2
5 P1970004 10 PSI MAX. LABEL
6 P1970005 AIR COMPRESSOR LABEL
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
EXPLOSION HAZARD!
Do not use an air compressor
to inflate the sanding drum!
Over-inflation will cause the
bladder to explode, resulting
in personal injury or tool
damage
2
5
3
4
6