Filter
Top Products
G4030 6
1
⁄2" x 10" Metal-Cutting Bandsaw
-15-
The shipping bracket keeps the saw from dam-
age during shipment and must be removed. The
switch control bracket is adjusted to shut the ON/
OFF switch when the saw returns to the horizon-
tal position.
To remove or adjust brackets:
1. Use a 10mm wrench to remove the shipping
bracket shown in Figure 6.
Brackets
Figure 7. Safety switch bracket.
Switch Control
Bracket
Figure 6. Removing shipping bracket.
Shipping Bracket
Vertical Assembly
The Model G4030 can easily be set up for vertical
cutting operations.
Components and Hardware Needed: Qty
Table ...................................................................1
To assemble the bandsaw for vertical cut-
ting:
1. If a piece of wood is clamped in the vise for
shipping purposes, rotate the handwheel
and remove the wood.
2. Lift the saw to the vertical position. Rotate
the feed ON/OFF valve to the OFF position,
as shown in Figure 8.
Figure 8. Feed ON/OFF valve and feed rate
dial.
Feed Rate
Dial
Feed ON/OFF
Valve
2. Loosen the hex nut holding the switch con-
trol bracket with a 10mm wrench (Figure 7).
Rotate the bracket so it is positioned over the
switch in such a way so when the switch con-
trol bracket makes contact with the switch, it
will push the switch down and OFF.