Grizzly G4815 Biscuit Joiner User Manual


 
-20- Ultimate Series Jointers
The surface of the infeed table must be perfectly
level with the surface of the outfeed table.
To verify the factory setting:
1. Position the edge of a steel straightedge on
the outfeed table so that it extends over the
cutterhead and onto the infeed table (Figure
19).
2. Loosen the infeed table height lock knob
(page 10, #9).
3. Turn the infeed table height handwheel (page
10, #8) to raise the infeed table until it just
touches the straightedge WITHOUT lifting it
off the outfeed table.
4. Tighten the infeed table lock knob.
5. Check the alignment of the tables with the
straightedge at the various points shown in
Figure 20. Again, the straightedge should sit
perfectly flat across both the infeed and out-
feed tables with no gaps.
6. If all the table adjustments are set correctly,
the depth-of-cut scale should read "0" as
shown in Figure 21. If these conditions are
not present, refer to Section 8: Service
Adjustments.
Figure 21. Depth of cut scale.
Figure 20. Positions for straightedge.
Figure 19. Verifying that the infeed table is
even with the outfeed table.
Infeed Table Just Touching
The Straightedge
NOTICE
Review the "Knife To Outfeed Table
Alignment" and the "Carbide Cutter To
Outfeed Table Alignment" sub-sections on
the previous pages before continuing.
Infeed Table To
Outfeed Table
Alignment
Straightedge