Filter
Top Products
Model G5352 Spray Gun-8-
2. Screw the cup onto the top of the
body.
3. Attach the air hose directly to the air fit-
ting on the spray gun or with a
1
⁄4" NPT
quick connect fitting (not included).
4. Attach the spray gun to a filtered, regu-
lated air source. See the Tool Data
Sheet on Page 8 for your spray gun air
requirements.
Note: For the best results, use a hose
that will be dedicated for spray use
only. Do not use a hose that has been
used with an in-line oiler or other pos-
sible contaminant.
If you need additional help with this assem-
bly, call our Technical Support at: (570)
546-9663.
1. Fluid Control: Controls the volume of
material that travels through the fluid
tip.
2. Pattern Control: Adjusts the spray
pattern from a round pattern to a wide
fan.
3. Air Flow Control: Controls the fluid
pressure inside the spray gun.
4. Atomizing Cap: Controls the spray
pattern from vertical to horizontal.
5. Trigger: Two stage trigger. Stage
one only releases compressed air for
blowing off the work piece. Stage two
sprays material. Lightly squeeze the
trigger for stage one. Squeeze the
trigger all the way to spray.
Controls
Figure 3. Controls.
Fluid Control
Pattern Control
Atomizing Cap
Trigger
Air Flow Control